Cut, Fuse, Repeat (Part 2)

Already, the glass has lost much of the “scrappy” look:

Re-fused scrap strips!

One more trip to the tile saw and then to kiln will complete the transformation.

Again you should cut 3/8 inch wide bars – but this time cut across the bars that we just fused together – like this:

Re-cutting the fused glass slab.

This trip to the tile saw results into this new, wonderful set of glass bars:

Our scrap "bars" keep getting better and batter!

As you did with the first pass, we are going to re-arrange the bars and fuse them back into a slab.  This time, though, we’re going to add a window to make our piece more interesting.

Click the “Final Design Setup” link below to continue.