dichrogirl

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #11587
    dichrogirl
    Participant

    Thanks for the suggestions.  I have been using thinfire paper, and yes many of the pieces are less than 6mm thick, expecially on the edges where I have “overhang”. from overlapping pieces.  I tried another firing using the soft fuse schedule (except that I did eliminate the steps after reaching 700 and just let the kiln cool on it’s own).  The results were much better, with only a few sharp points.  Most of these appeared to be the result of cutting rather than firing.  Should I try adding about 5 degrees or a longer hold? 

Viewing 1 post (of 1 total)

People Who Like Thisx

Loading...