I’ve done irrid to irrid with great results – I use a resist on one or both sides of the irrid glass, draw out my design and cut it out and sandblast the irrid off where I don’t want it to get some spectacular results. If you want to do irrid to irrid and both sides retain full irrid coating you will still need to take the coating off of both sides all around the edges, an 1/8 inch or so, or it will not seal – you can take it off with a grinder but a belt sander would be faster and easier.
Viewing 1 post (of 1 total)
Copyright Izm Studio, LLC. All rights reserved. Copying content from this site is a violation of applicable copyright laws and will be prosecuted.