Viau

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #13478
    Viau
    Participant

    I realise that the glass was at 10″ from the lid élément.

    Maybe the temperature on the surface of the glass Is not even because the glass Is to far from the lid. So the side Is warming up faster than the center of the surface?

    #11798
    Viau
    Participant

    I do agree with Suzan K about the two possibilities for the blowing up of your mold.

    Conserning the firing of the low firing clay,I suggest you to verifiy with the maker of the clay.

    When I made my molds of low firing clay I used the code “cone”firing schedule.I have the option between glass or ceramic firing.Pottery (clay) is not as difficult to fire than glass.When I used cone firing,I had the option low,medium or fast firing.I used cone 08 (1750*F) .It went to room temperature to 1750*F. Than at 1750*F I shut down the kiln(at off).

    The next morning, the mold was fine and I still used them often.Sylvio

    #13030
    Viau
    Participant

    Thanks for the info.I will try the liquid stringer.I tried other medium but didn’t find what I was looking for.

    #13022
    Viau
    Participant

    Thanks for you tutorial.Was very helpful.

    #13020
    Viau
    Participant

    Thanks, I will try it to see if it works for me.

Viewing 5 posts - 1 through 5 (of 5 total)

People Who Like Thisx

Loading...