Paul Tarlow

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #15888
    Paul Tarlow
    Keymaster

    There was a problem – but it should be fixed now. Thanks.

    #15706
    Paul Tarlow
    Keymaster

    Please send an email to help@fusedglassbooks.com

    #15638
    Paul Tarlow
    Keymaster
    #15213
    Paul Tarlow
    Keymaster

    Any media will work. The goal is to rough up – not remove – the finish.

    #15080
    Paul Tarlow
    Keymaster

    Yes – I’ve used and taught with it.

    You can do cane with it – look at some of the online tutorials for polymer clay. Those instructions should be fairly adaptable.

    #14800
    Paul Tarlow
    Keymaster

    Difficult to know for sure, but sounds like a slumping mold.

    #14419
    Paul Tarlow
    Keymaster

    Deep square and rectangular molds will almost always end up with curved edges that dip in towards the center. Slower slumping will minimize this. You can probably get to straight edges if the flat piece has sides that are bowed out – but it would require testing.

    #14354
    Paul Tarlow
    Keymaster

    You can always perform the anneal-hold at a higher than required temperature so I would continue to hold at the prescribed temperature and maybe extend the anneal cooling a bit lower.

Viewing 8 posts - 1 through 8 (of 8 total)

People Who Like Thisx

Loading...