Candace0523
Candace0523 replied to the topic Shrinkage after slumping in the forum General Fusing Discussion 1 week ago
Thanks Paul – I’ll give another one a try with a slower schedule!
-
Candace0523 started the topic Shrinkage after slumping in the forum General Fusing Discussion 1 week, 1 day ago
I have a 5×7 piece (6mm) that I slumped into a fairly deep rectangular mold – it came out just “curved” versus down into the sloped shape. I slumped it again at a higher temperature, and it literally shrunk by 1/2” on all sides, and thickened up in the middle (it still didn’t take the form of the mold). Any ideas what happened?
-
Candace0523 became a registered member 1 week, 1 day ago
