Sconce making or a cheap source?

Home Forums Glass Fusing General Fusing Discussion Sconce making or a cheap source?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #9457
    mterry
    Participant

    I was contacted by a designer in SoCal to make some small sconces for a restaurant. (4-5 inches wide). Does anyone have instructions on how to make a wall sconce, with or without a light? I don’t know yet if they want a light or candle.

     

    All the sconce brackets I found are too big and/or pricey, so I guess I will have to make them.

     

    TIA-

    Marge

    #11705
    petra kaiser
    Participant

    I think you definetly need to know what kind of light fixture you need. If it is about the mold, I can show you how to make one really easy with Kaiser Lee Board in any size you want your final sconce to be.

    petra kaiser – http://www.kaiserlee.com – Students Blog: http://www.myglassart.or

    #11704
    mterry
    Participant

    Thanks Petra, I had forgotten about the KLB, it would make the perfect mold! I’ll check on the sconce type and post the answer

    Marge

    http://www.TerryStudios.com

    #11706
    mterry
    Participant

    I need a cheap/fast source or instructions for making a candle sconce bracket for a 1/3-1/2 round 4 inch sconce. Any suggestions?

    Marge

    http://www.TerryStudios.com

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.

People Who Like Thisx

Loading...