Repairing a broken slumped platter

Home Forums FusedGlass.Org Website Help Forum Help Repairing a broken slumped platter

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #10323

    A sushi platter, 12 x 12, fused with 2 layers plus accents on top broke into 4 pieces when dropped.  What temperature is recommended to flatten the pieces and then put them back together on a (thin?) clear layer and refire?  Is this possible?  Thanks for your help.



    In no way am I setting myself up here as all-knowing but your question certainly deserved a good answer. So here’s a start.


    In my experience I haven’t been so successful at this endeavor.  Either my pattern came out misshapen or I managed to get devit.  I would certainly spray for devit and if you think your pattern is likely to Spreeead and then contort, perhaps just putting some frit between the existing pieces as a design inclusion might work?

    Hope this helps!

    Windows listen attentively for the sound of broken glass.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

People Who Like Thisx