Can anyone speak authoritatively on the subject of polishing glass with a hand polisher? What grits of diamond abrasives/pads/discs should be use, leading up to felt with Cerium Oxide? What RPMs with each grit/felt? Once you’ve gotten a completely level surface at the lowest grit, roughly how long each step (each finer grit) should take? Let’s assume a six inch square, flat, 6mm thick piece of fused glass… Are there differences between opal and transparent glass?
Thanks so much!
PS: This assumes all polishing is wet, plenty of water to keep the glass cool…
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Copyright Izm Studio, LLC. All rights reserved. Copying content from this site is a violation of applicable copyright laws and will be prosecuted.