I am a new member (and very new to glass fusing). I would like to get a glass kiln and was looking at Bonnie Glo tall – this is a new Jen Ken model. I am confined to 110V (to get 240 I would need to replace the breaker box and that is just too pricey), and this kiln seems to be on the bigger side – 15″ diameter – and I especially like the 9″ height – other kilns I looked at were about 6.5″ tall.
Does anyone has experience with fiber (as opposed to brick) kilns? What are pros and cons? I know one should not do a pot mold in a fiber kilns, are there any other things I could not do? What is your experience with Jen Ken – are those good kilns?
Thanks in advance for any advice you can provide.
Have a lovely day!
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Copyright Izm Studio, LLC. All rights reserved. Copying content from this site is a violation of applicable copyright laws and will be prosecuted.