I have just finished firing a 17″ diameter round piece using 2 layers of Bullseye glass. There are some additional components on the top in about a 3″ x 4″ area square. When I removed the piece from the kiln there appears to be a squiggly crack between the layers that runs about 12″. Is there any method I can use in the kiln that will make the line disappear?
Author
Posts
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Copyright Izm Studio, LLC. All rights reserved. Copying content from this site is a violation of applicable copyright laws and will be prosecuted.