A piece that was a pot melt within a frame and then fired again on another larger base piece came out looking okay .It was slumped into a very shallow plate mold. I checked it over and top looked okay, bottom appears to have 2 running cracks within part of the interior. They do not come to the surface on either side.
Is it possible to save this piece in any way by firing again? If so, what would be the schedule?
Author
Posts
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Copyright Izm Studio, LLC. All rights reserved. Copying content from this site is a violation of applicable copyright laws and will be prosecuted.