fused panels

Home › Forums › Glass Fusing › General Fusing Discussion › fused panels

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 15, 2011 at 8:23 pm #9670
    Shelle
    Participant

    I have a silly, newbie question.  I have been doing a lot of casting and fusing of small pieces, but would like to try my hand at something bigger.  I have been looking for molds to make a panel in, but can’t seem to find much.  Is this something I would use a glass dam for? 

    Thanks!

    Shelle

    September 16, 2011 at 2:50 am #12209
    wordana
    Participant

    You can use glass dams, kaiser-lee board, or stainless rings. Slumpy’s has a good supply of stainless, including squares:

    http://www.slumpys.com/SlumpysStore/product_Stainless_Steel_Casting_Square_Molds_SS-793-797VGH13392VGH959VGH666VGH5VGH.aspx

     

    Dana W.

     

    September 16, 2011 at 2:31 pm #12210
    Shelle
    Participant

    Kaiser board will be perfect!!  Why didn’t I think of that?  I feel a little silly for not seeing such an obvious answer.  Thank you very much!

    September 17, 2011 at 2:46 am #12211
    wordana
    Participant

    Well, not a lot of people use KLB (at least that I hear of), so you can go easy on yourself :)

     

    Dana W.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.

People Who Like Thisx

Loading...