Fused glass results soft edge

Home Forums Glass Fusing General Fusing Discussion Fused glass results soft edge

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #10486
    gailc
    Participant

    After fusing 2 standard pieces of glass (9X9 inch square), I went to remove the piece. This resulted in a corner breaking off. This corner didn’t “snap” off. It fell off like a soft piece of candy. I used the same fusing program and glass from the same large piece of glass as a previous piece that turned out well!

     

    Any suggestions as to what may have happened? Also, what should I do to prevent this from happening again?

    Thank you.

    Gail C

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

People Who Like Thisx

Loading...