Home › Forums › Glass Fusing › General Fusing Discussion › frit casting
I have a wonderful large spiral mold for frit casting and eventually forming a bowl. I’m not sure how to proceed so I have a few questions:
1. Do I cast first, then tack fuse the casting on to the fused rounds and then slump? Or what?
2. How do I know how much frit to use to fill the mold so that I get a full flat spiral?
3. If I were to fill the spiral and top with sheet glass, what would I have to look out for?
Thanks.
A picture of the mold might help.
Dana W.
Jester’s Baubles Fused Glass Designs
http://www.jestersbaubles.com