Deep Glass bowl
Home › Forums › Glass Fusing › General Fusing Discussion › Deep Glass bowl
- This topic has 4 replies, 3 voices, and was last updated 9 years, 4 months ago by Anonymous.
- November 15, 2013 at 2:38 am #10044lovleylisParticipant
Looking for some advice on making a large deep bowl. Where to start for slumping?? I have tried slumping and draping with no good results…November 15, 2013 at 3:23 am #13109wordanaParticipant
Bullseye makes a set of bowls where you accomplish the finished piece in multiple firings — starting with a shallow slump and slumping in a little deeper mold with each firing:
Another option is to check out Paul Tarlow’s “Fused Glass Drop Vessels” ebook. It’s a lot simpler than using the progressive molds
Jester’s Baubles Fused Glass DesignsNovember 15, 2013 at 3:46 am #13110lovleylisParticipant
Thank you, unfortunately Im bummed that its such processNovember 15, 2013 at 4:23 am #13111wordanaParticipant
If it were easy, everyone would be doing it.
Jester’s Baubles Fused Glass DesignsNovember 18, 2013 at 7:44 pm #13112AnonymousInactive
Using the Bullseye deep mold set can work but it isn’t easy. Getting the glass to fall evenly – even with the mold set – is difficult. It requires a large kiln that heats very evenly.
With drop-out vessels it is easier to get an even drop – but cutting the rim (especially on larger pieces) can be challenging.
Helios Kiln Glass Studio
- You must be logged in to reply to this topic.