Beginners Questions on Issues – Sharp Points and Devit

Home Forums FusedGlass.Org Website Help Forum Help Beginners Questions on Issues – Sharp Points and Devit

This topic contains 0 replies, has 1 voice, and was last updated by  paulgliesman 1 year, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #10417

    paulgliesman
    Participant

    I cut out 2 pieces of Bullseye glass for an eight inch plate.  In the center I put the outline of Michigan.   I followed the 2 piece, 6 mm firing (1475 F and hold for 10 min).  The results – The two round pieces for the plate fused fine.  the small state pieces 1) did not fully fuse, 2) had sharp small bumps at the points, and 3) there was some devit on the white glass of the state outline.

    I have a Devner kiln, 21 x 21 kiln.  I did peek at the glass at the last 2 minutes of the 1475 hold time but did not see the above issues until the glass was cool.

    I don’t have enough experience to know whether to increase / decrease the temp or adjust the hold time.  Any help would be appreciated.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

People Who Like Thisx

Loading...