Thanks, Dana! I will check
Home › Forums › Glass Fusing › General Fusing Discussion › first drape attempt › Thanks, Dana! I will check
Thanks, Dana! I will check my manual for my programmable controller (Skutt). If that function is there, so I (as in your case) use the up arrow (or whatever my kiln requires) during the segment I want to “skip” thus ending that segment at that point and moving it immediately to the next (anneal) segment? And would I do that when the piece is at the point that I want it to stay or slightly before taking into account that it will probably move a little until it cools a bit?
I’m pretty conservative with temps and it’s working out so far, but I have no idea what “too high” would be. I’m going to start with a small piece and see how I do.
Thanks again!!
Kathy