Ed is referring to what is
Home › Forums › Glass Fusing › General Fusing Discussion › What’s the best way to get a hole in a thicker project to place clockworks? › Ed is referring to what is
September 15, 2008 at 7:55 pm #10826
AnonymousInactive
Ed is referring to what is called the “throat capacity” of the drill press. It is the distance from the center of the chuck (where the bit goes) to the closest edge of the column on which the drill is mounted.
It is the maximum distance from the edge of the piece you are drilling that you can drill before the drill press column/post gets in the way.
Paul
FusedGlass.Org
Helios Kiln Glass Studio
PaulTarlow.com
