Drilling Holes in Glass
Home › Forums › Glass Fusing › General Fusing Discussion › What’s the best way to get a hole in a thicker project to place clockworks? › Drilling Holes in Glass
September 23, 2008 at 12:52 pm #10832
windfireParticipant
Hi,
Which ever way you do the drilling, please be sure that the electrical cord and motor are properly grounded and that there is a drip loop so no water can run down the cord to the electrical socket.
I used the drill press method and have bought a GFIC protected extension cord to use with it.
Debby
