Cuttiong pressures
Home › Forums › Glass Fusing › General Fusing Discussion › Cutting new SP advertine glass › Cuttiong pressures
April 15, 2010 at 4:40 pm #11586
Participant
Paradoxically, too much pressure at the scoring stage can cause problems when breaking. So a difficult to cut glass may need less pressure than you normally use – as you may be using too much pressure alaready. Have a look at the Bullseye website under education where there is a note on cutting pressures.
Stephen Richard
blogs at: http://www.verrier-glass.blogspot.com/ and http://www.glasstips.blogspot.com/