kiln wash

Will kiln wash hold up at 1600 degrees F?  Or will it stick to the glass?

The kiln wash will do it's

The kiln wash will do it's job at that temp - which is to say it will prevent your glass from sticking to the kiln shelf.

That said, you will likely get some kiln wash peeling off the shelf and sticking to the glass.  That isn't a problem though - when the class fully cools just soak it in vinegar for about 20 minutes and the kiln wash will come right off with a soft brush.

You will need to scrape and re-kiln wash the shelf. 

----------------------
Paul
FusedGlass.Org
Helios Kiln Glass Studio
PaulTarlow.com

 

Kiln Wash

Paul is correct. I do a lot of pot melts and that glass is melting at 1700 degrees for two hours. Very seldom do I have a problem with the melt actually sticking to the shelf. When I do I figure that it happened because I didn't cover the shelf completely. I just sandblast it off and refuse, which I need to do anyway because of all the bubbles on the surface at that temp. 

Use of Vinegar

Paul,

I've tried the vinegar and it didn't work for me. Any idea why?

Thanks,

Ann Marie

Kiln wash

The only time I have significant problems removing kilnwash is when I got sloppy with the devit spray. Particularly around the edges, if the spray settles into the kilnwash it basically makes borax glass on the underside of the fused piece. That is very difficult to remove.

sandblasting setup

I realize this is an older post, I am curious as to your sandblasting set up.  I am somewht confused over the siphon vs pressure pot systems.  I have a compressor, 7CFM with 90psi. 4 HP and 11 gallon tank.  Most cabinet set ups want 11-14 CFM, then I found an article about using a smaller

nozzle to compensate for lower CFM.  I  have looked at tptools and northern tool, harbor freight and Grainger and texas blaster.  Any comments/suggestions welcome.

thank you

Pressure pot

Your set up should be perfectly adequate for a pressure pot system.  A bit underpowered and lacking in air storage for siphon.

Stephen Richard

blogs at: http://www.verrier-glass.blogspot.com/   and  http://www.glasstips.blogspot.com/

kiln wash

 I converted a 70 gallon plastic pickle barrel by cutting off one end and building a window into it as well. I use a small sandblaster called a "speed blaster." It has a small reservoir for the blasting media (I use silicon carbide), which is a pain to continuously reload, but it doesn't take much air pressure to work well. I have used this very inexpensive setup to blast fairly extensive projects. It works really well for getting rid of a bit of kiln wash.

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.